Rotel RSX-1560 Owner's Manual Page 17
- Page / 54
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
16 17
English
RSX-1560 Surround Sound Receiver
16 17
English
RSX-1560 Surround Sound Receiver
OVERVIEW OF CONNECTIONS
Although the rear panel may look daunting, connecting the unit to your
system is straightforward. Each of the source components in the system
are connected to the receiver’s inputs with a pair of standard RCA cables
for analog audio, a video connection (Composite, S-Video, Component
Video, and/or HDMI), and an optional digital audio cable (coax or
optical).
Note: Surround formats like Dolby Digital and DTS are digital
formats and the receiver can only decode them when a digital
input signal is available. For this reason, you should always
connect your DVD player’s digital outputs to the receiver, using
either the optical or coax inputs.
The outputs of the receiver are sent to up to five speakers, or to optional
power amplifier(s) with standard RCA cables from the preamp audio
outputs. The video signal from the RSX-1560 is sent to the TV monitor
using Composite video, S-Video, Component Video, and/or HDMI
connections.
In addition, the receiver has MULTI input connections for a source
component that does its own surround decoding, remote IR sensor
inputs, and 12V trigger connections for remote turn-on of other Rotel
components.
Note: Do NOT plug any system component into an AC source
until all connections have been properly made.Video cables
should have a 75 ohm impedance. The S/PDIF digital audio
interface standard also specifies a 75 ohm impedance and all
good digital cables adhere to this requirement. Do NOT substitute
conventional audio interconnect cables for digital or video signals.
Standard audio interconnects will pass these signals, but their
limited bandwidth reduce performance.
When making signal connections, connect LEFT channels to LEFT
channel jacks and RIGHT channels to RIGHT channel jacks. All RCA-type
connections on this product follow these standard color codes:
Left channel audio: white RCA jack
Right channel audio: red RCA jack
Composite video: yellow RCA jack
Note: Each source input must be properly configured using the
INPUT SETUP menu of the OSD menu system. We recommend
going to this menu after connecting each source to configure it as
desired. See Input Setup in the Setup section for information.
Video Inputs & Outputs
These connections are used for connecting video signals to and from the
unit. See the Making Connections section for specific instructions for each
type of component.
The RSX-1560 provides Composite, S-Video, Component Video,
and HDMI connections Composite video connections simplify system
configuration; however, S-Video connections typically provide better
picture quality. Component Video or HDMI connections provide the best
signal quality and are required for HDTV or progressive scanned DVD
video.
Note: For proper operation, all HDMI components and TVs
connected to this receiver should be compatible with the HDMI
Version 1.1 standard or higher. The HDMI digital connections
are usually compatible with DVI components with an appropriate
DVI-D cable adapter. For more information see the section HDMI:
Frequently Asked Questions, in this manual.
√√√√√√√√√√
√√√√√√√√√√
√√√√√√√
√√√√√
√√√√√
√√√√√
√
√
√
√
√
√
√
VIDEO INPUT/OUTPUT FORMATS
Input video formats supported: 480i, 576i, 480p, 576p, 720p60, 720p50,1080i60, 1080i50, 1080p60, 1080p50
60Hz video input gives 60Hz video output; 50Hz video input gives 50Hz video output
RSX-1560 English v2.indd 17 29/9/08 15:15:54
- RSX-1560 1
- > 10 cm 2
- > 4 in 2
- > 10 cm > 4 in 2
- Important Safety Instructions 3
- 1: Controls and Connections 4
- Turn off the RSX-1560 5
- 6
- 7
- 10
- 11
- 13: On-Screen Menus 12
- Contents 13
- About Rotel 15
- Getting Started 15
- OVERVIEW OF CONNECTIONS 17
- Video Inputs & Outputs 17
- B and PR) signals, allowing 18
- Audio Inputs & Outputs 19
- Other Connections 20
- MAKING CONNECTIONS 22
- B on the 23
- B input on the TV 23
- R on the receiver 23
- R input on the TV 23
- OPERATING THE RSX-1560 26
- Front Panel Overview 26
- Remote Control Overview 26
- Basic Operations 28
- Selecting Inputs 29
- Overview of 30
- Surround Formats 30
- Automatic Surround Modes 32
- Manually Selecting 33
- Surround Modes 33
- Other Settings 35
- Tuner Controls 36
- RDS and RBDS Tuning 38
- Remote Zone Operation 39
- Menu Basics 40
- Configuring Inputs 41
- Configuring 44
- Speakers and Audio 44
- Subwoofer Setup 46
- Miscellaneous Settings 48
- 49
- Default Setup 50
- MORE INFORMATION 51
- Troubleshooting 51
- Specifications 53
Related products and manuals for AV receivers Rotel RSX-1560
AV receivers Rotel RSX-1065 Owner's Manual
(32 pages)
(32 pages)
AV receivers Rotel RSP-1066 Owner's Manual
(76 pages)
(76 pages)
AV receivers Rotel RSX-972 Owner's Manual
(68 pages)
(68 pages)
AV receivers Rotel RSX-1057 Owner's Manual
(48 pages)
(48 pages)
AV receivers Rotel RSP-1068 Owner's Manual
(44 pages)
(44 pages)
AV receivers Rotel RSP-976 Owner's Manual
(56 pages)
(56 pages)
AV receivers Rotel RSX-1055 Owner's Manual
(36 pages)
(36 pages)
AV receivers Rotel RSX-1065 Owner's Manual
(36 pages)
(36 pages)
© 2020, manymanuals.com. All rights reserved. | 1.044 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals