Rotel RSP-985 User Manual download pdf (Page 20)

SURROUND SOUND PROCESSOR RSP-985

System Status Screen

SYSTEM STATUS

Listen:

Mode :

Domain:

Signal:

Main Volume : dB

Surr Offset : dB

THX :

Rec Out......:

Zone 2 In....:

Zone 2 Volume:

Press ENTER for menu

The SYSTEM STATUS screen provides the status all of the impor-

tant settings of the RSP-985 and a starting point for reaching all

other screens and menus. This screen is available at any time by

pressing the ON-SCREEN button on the remote control. The

screen displays the following status information:

LISTEN: the current source selected

MODE: the current surround mode

DOMAIN: whether a DIGITAL or ANALOG signal is active for the

listening source

SIGNAL: type of digital signal available at the selected input, for

example: DOLBY DIGITAL, DIGITAL AUDIO, DTS, NO SIGNAL, or

ANALOG

MAIN VOLUME: the output volume setting

SURR OFFSET: a temporary increase or decrease in the surround

speaker volume for more or less emphasis on surround effects.

The setting is made with the SEARCH +/– buttons on the RR-939

remote and reverts to the calibrated settings when the surround

mode is changed or the unit is powered off.

THX: current status of the additional cinema circuitry – THX ON,

THX OFF, or RE-EQ ON.

REC OUT: which source is selected for the recording outputs

ZONE 2 IN: which source is selected for Zone 2

ZONE 2 VOLUME: the volume setting for Zone 2

The SYSTEM STATUS screen simply provides information. None of

the settings can be adjusted from this screen. To make changes to

the settings, go to the MAIN MENU by pressing the ENTER button

on the remote control, as indicated at the bottom of the SYSTEM

STATUS screen.

Main Menu Screen

MAIN MENU

Digital audio..: menu

Input setup....: menu

System setup...: menu

Speaker Setup..: menu

Delay Setup....: menu

Balance Setup..: menu

Subwoofer Setup: menu

ENTER to enter menu

DOWN/UP to move

BACK to exit

The MAIN MENU screen is the entry point for all of the RSP-985’s

settings and setup menus where system configuration settings

can be made. These are typically accessed only during initial sys-

tem configuration and are not used in day-to-day operation:

DIGITAL AUDIO MENU: Reach this menu by moving the highlight

to this line and pressing the ENTER button. This takes you to a

menu for setting up digital sources.

INPUT SETUP: Reach this menu by moving the highlight to this line

and pressing the ENTER button. This will take you to a menu for

configuring each input including selection of digital or analog

connections, type of digital connection, input levels, etc.

SYSTEM SETUP: Reach this menu by moving the highlight to this

line and pressing the ENTER button. This takes you to a menu for

basic system settings, Zone 2 settings, etc.

SPEAKER SETUP: Reach this menu by moving the highlight to this

line and pressing the ENTER button. This will take you to a menu

for configuring the number and type of speakers in the system.

DELAY SETUP: Reach this menu by moving the highlight to this

line and pressing the ENTER button. This takes you to a menu for

configuring delay times to each speaker in surround modes.

BALANCE SETUP: Reach this menu by moving the highlight to this

line and pressing the ENTER button. This will take you to a menu

for configuring the relative volume levels of each speaker .

SUBWOOFER SETUP: Reach this menu by moving the highlight to

this line and pressing the ENTER button. This takes you to a menu

for configuring your subwoofer for various surround modes.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Rotel RSP-985 User Manual Page 20

Comments to this Manuals

Related products and manuals for Receiver Rotel RSP-985